|
Product Details:
|
| Operating Principle: | 3-electrode Electrochemical | Measurement Range: | 0-40,000 Ppm CO |
|---|---|---|---|
| Maximum Overload: | 100,000 Ppm CO | Filter: | High Capacity Filter To Remove Acid Gases From Flue Stream |
| Sensitivity*: | 0.007 ± 0.002 μA/ppm | Resolution: | 10 Ppm |
| Response Time (T90)*: | <30 Seconds | Baseline Offset (clean Air): | Baseline Offset (clean Air) |
| Zero Shift (+20°C To +40°C): | <200 Ppm Equivalent | ||
| Highlight: | 3MF 3 Series CO Gas Sensor,200 ppm CO Gas Sensor |
||
3MF 3 series electrochemical Carbon Monoxide (CO) Gas Sensor Range of accessories available
This sensor is designed to be used in safety critical applications. To ensure that the sensor and/or instrument
in which it is used, are operating properly, it is a requirement that the function of the device is confirmed by
exposure to target gas (bump check) before each use of the sensor and/or instrument. Failure to carry out
such tests may jeopardize the safety of people and property.
The cross sensitivity data shown below does not form part of the
product specification and is supplied for guidance only. Values quoted are based on
tests conducted on a small number of sensors and any batch may show significant
variation. For the most accurate measurements, an instrument should be calibrated
using the gas under investigation.
| Weight | 22 g |
| Orientation | Any |
| Operating Temperature Range | -20°C to +50°C |
| Recommended Storage Temp | 0°C to 20°C |
| Operating Pressure Range | Atmospheric ± 10% |
| Operating Humidity Range | Operating Humidity Range |
Contact Person: Miss. Xu
Tel: 86+13352990255
