Product Description:
YJJ MSH-P/CO2/NC/5/V/P/F Non-dispersive Infrared Carbon Dioxide Sensor
Features:
Carbon dioxide sensor MSH-P/CO2 Description:
Used for detecting carbon dioxide within the ppm and % volume range
The Dynament infrared sensor uses the NDIR principle to monitor the presence of the target gas. This sensor contains a long-life tungsten filament infrared light source,
an optical cavity for the gas diffusion,
a dual-temperature compensated thermoelectric infrared detector, an integrating semiconductor temperature sensor and electronic equipment to process the signals from the thermoelectric device.
A dual-gas version is available, designed to detect both hydrocarbons and carbon dioxide. The 20mm diameter packaging is for the carbon dioxide sensor, and the dual sensors can be used with digital communication.
Dynament carbon dioxide sensor MSH-P/CO2 Characteristics:
· Provides 3 power supply variants, 80mA, 15mA and 8mA
Industrial ExdIC certification and mining M1 certification can be used for all variants
· SIL1 certification can be used for most variants
Measuring carbon dioxide from 0 to 10,000 ppm, with a resolution of 10 ppm
Measuring carbon dioxide from 0 to 100% v01. The resolution is as low as 0.01%
Compared with earlier versions, the response time is shortened
· Selection of output format: digital output (floating point and binary), direct pellistor replacement or industry standard 0.4 to 2 volts
Manual calibration options can be executed without digital commands
User-configurable using a USB-powered Premier Configuration Unit
· Output can be scaled by % volume or % full scale
Built-in flash memory allows the sensor firmware to be updated through the configuration unit
· Enhanced EMC protection
Core parameters
Operating voltage: 3.0 - 5.0 VDC
Operating current: 75 - 85 mA (constant current)
Detection range: 0 - 5%, 0 - 4%, 0 - 3%, 0 - 2%, 0 - 1% vol CO₂
Resolution: 0.5% (above 50% of the range), 1% (below 50% of the range)
Performance indicators
Response time: T90 < 30 seconds (at ambient temperature of 20℃)
Preheating time: Reaches zero point ±100 ppm in 1 minute (at ambient temperature of 20℃)
Long-term zero drift: ±500 ppm per month (at ambient temperature of 20℃)
Environmental adaptability
Operating temperature: -20℃ to +50℃
Humidity range: 0 - 95% RH with no condensation water
Output Configuration
Voltage Output: 0.4 - 2.8 VDC (adjustable)
Digital Signal: 8 data bits, 1 stop bit, standard baud rates of 38400, 19200, 960
Other characteristics
Protection level: Industrial Ex d IIC certification, Mining M1 certification Average Mean Time Between Failures: > 5 years
Specifications:
| Working Voltage |
3.0 - 5.0 VDC |
| Working Current |
75 - 85 mA (constant current) |
| Detection Range |
0 - 5%, 0 - 4%, 0 - 3%, 0 - 2%, 0 - 1% vol CO₂ |
| Resolutio |
0.5% |
Your message must be between 20-3,000 characters!
