Detection principle:Solid Polymer Electrochemical Gas Detection Technology
Operating current:0.65mA @ 5V DC
Power-on stabilization time:< 2min (no Need To Warm Up The Machine, Just Power On And Test)
Response time (T90):≤20 Seconds
Maximum detection concentration:2.0 Mg/L
Repeatability:±0.006 Mg/L
Resolution:1-2000 Ppb (optional)
Detection range:0-10000 Ppm (optional)
Operating pressure range:800~1200 Mbar
Maximum Overload:200 Ppm
Resolution (Electronics dependent):0.1 Ppm Typical
Output signal:600 ± 150 NA / Ppm
Detection:N2O
Humidity range 0 ~ 95%RH(No condensate):0 ~ 95%RH(No Condensate)
Operating temperature:-40℃ ~ +70℃
Zero cument:0 To 15
Diameter:20 Mm
Response timet90:(s) <75
Resolution:1
Sensitivity:27 To 55
Response time:< 25
Output signal:UART, Modbus RTU Protocol. 3.3V TIL Level
Working temperature:-15 To 45 Degrees Celsius
Detection range:0-1500/2000/3000ppm; Can Be Expanded To 5000ppm
Working humidity:0~95%RH (no Condensation)
Warm-up time:1 Minute
Detection principle:Non-dispersive Infrared (NDIR) Principle
Operation Principle:3-Electrode Electrochemical
Resolution (Electronics dependent):< 0.5 Ppm
Typical Baseline Range (pure air, 20°C):-4 Ppm To 4 Ppm
Operating voltage:3.3 To 12V DC, 5V DC Recommended
Operating current:0.65mA @ 5V DC
Detection principle:Solid Polymer Electrochemical Gas Detection Technology
perating humidity range:15-95%RH. Non-condensing
Detection principle:Solid Polymer Electrochemical Gas Detection Technology
Power-on stabilization time:< 2min (no Need To Warm Up The Machine, Just Power On And Test)
