Operating temperature range:-30 to 50
degrees (continuous:-20 to 40 degrees
Operating humidity range:0 to 100% RH (lasting 15 to 95%)
Measurement Range:0 to 5 ppm
Lower Detection Limit**:< 20 ppb (instrumentation dependent)
Response Time:< 15 seconds typical
Nominal Range:0 ~ 10 ppm
Maximum Overload:30 ppm
Sensitivity (20°C):1.5 ± 0.5 μA/ppm
Nominal Range:0 ~ 5 ppm
Maximum Overload:20 ppm
Sensitivity (20°C):-0.50 ± 0.15 μA/ppm
Sensor Type:MEMS
Standard Encapsulation:Ceramic
Detection Gas:NH3 etc
Operating Humidity:Low
Signal Output:Analog
Operating Temperature:Wide Range
Operating humidity:15%-95%RH (non-condensing)
Measuring gas:Carbon Monoxide (CO)
Zero drift:<3ppm
Range:Carbon Monoxide: 0 - 1000 ppm / Hydrogen Sulfide: 0 - 200 ppm
Output:CO: 60 to 120 nA/ppm / H2S: 500 to 1100 nA/ppm
Overload resistance CO:< 30 seconds
Repeatability:< 2%
Recommended Load Resistor:10 Ohm
Measurement Range:0-2000 Ppm
Operation Voltage:2-12V
Responsivity, min.:2.2-3.5kV/W
Responsivity, typ.:3.5-5.0kV/W
Output sensitivity:12 mv / % methane
Temperature range:-40°C + 50°C
Pressure range:1 atm + 10%
Output voltage:9 ~ 13 mV (in ambient air)
Measurement range:0 ~ 100%
Response time (T90):< 15 s